Items: 0 Total: £0.00

Forgotten your password?
.

 
  Home > 1909 Spares

Magneto SparesMagneto Spares

ImageNameDescriptionPriceQty 
Ball 1/4 Pack of 48
Ball 1/4 Pack of 48Ball 1/4 - Pack of 48£3.45
Ball 3/16 Pack of 48
Ball 3/16 Pack of 48Ball 3/16 pack of 48£3.45
Ball 5/32
Ball 5/32

Ball 5/32

sold per ball at £0.10 each

£0.11
Ball 50 x 1/8
Ball 50 x 1/8Ball 1/8 in a pack of 50 £3.45
Ball 7/32
Ball 7/32

Ball 7/32

sold as one ball at £0.10

£0.11
Bearing MC22
Bearing MC22

MC22 RS bearing single row bearing 22 x 50 x 17mm.

Now with a oil seal in one side also.

£40.00
Bearing upper race set Veterans and Model H/SD and Ricardo
Bearing upper race set Veterans and Model H/SD and RicardoBearing upper race set veterans and model H/SD and ricardo
Inter and out race no balls
£50.60
Bolt 1/4 Crankcase  domed end 3.900
Bolt 1/4 Crankcase domed end 3.900Crankcase bolt domed end 1/4 thread x 3.900 long with 1.100 long on thread cut down to suit early models£6.90
Bolt Crankcase 1/4 stud x 4 1/2 long for exhaust
Bolt Crankcase 1/4 stud x 4 1/2 long for exhaustCrankcase bolt 1/4 threaded both ends used to hold on Exhaust casting one needed.4 1/2 inch long£4.02
Bolt crankcase stud 1/4 x  4 1/4 long
Bolt crankcase stud 1/4 x 4 1/4 longCrankcase bolt 1/4 x 4 1/4 long threaded both ends for veteran case .
Approximately 4 used in the case plus one long one for exhaust.
£4.02
Bolt domed head Engine to frame 1/2 x 2.90 long
Bolt domed head Engine to frame 1/2 x 2.90 longBolt domed head Engine to frame 1/2 x 2.90 long£8.05
Bolt domed head engine to frame 9/16 x 3 long
Bolt domed head engine to frame 9/16 x 3 longBolt domed head engine to frame 9/16 x 24 tpi x 3 long£8.63
Bolt eccentric clamp and nut
Bolt eccentric clamp and nutEccentric bolt that clamps pedalling gear casting in the frame with square head nut.£20.70
Bolt Engine to frame 3/8 x 2.900 long domed head
Bolt Engine to frame 3/8 x 2.900 long domed headBolt Engine to frame 3/8 x 24 tpi x 2.900 long domed head.£6.90
Bolt for Mudguards 1/4 x 1/2 long
Bolt for Mudguards 1/4 x 1/2 longBolt for Mudguards stays 1/4 x 1/2 long with built in washer.£6.00
Bolt fork Pivot to spring
Bolt fork Pivot to springFork Buttress bolt that clamps to the spring housing
5/16  x 30 tpi special thread

Thread to under side of head.
£10.00
Bolt lubrication screws
Bolt lubrication screwsBolt lubrication screws 8ba thread with screwdriver slot£2.30
Bolt Magneto long square head
Bolt Magneto long square headMagneto Bolt long square head to bolt the magneto to the platform 3/8 whit thread.£17.00
Bolt Magneto short square head
Bolt Magneto short square headMagneto bolt short square head 3/8 whit to bolt Mag to platform. £14.50
Bolt rear Carrier veterans
Bolt rear Carrier veteransBolt rear Carrier veterans 3/8 and a 5/16 thread and 3/8 wide on hex
Will need a thin nut and split pin.
see nut section thin nut is 3/8 x 24 tpi x 0.16 wide
£12.65

Page
« Prev |1|2|3|4|5|6|7| Next »

Telephone : +44 (0) 777 3324238 
email: parts@veterantriumph.co.uk

Privacy & Cookies