1910 Spares

Home > 1910 Spares

Magneto Spares

Image	Name	Description	Price	Qty
	Ball 1/4 Pack of 48	Ball 1/4 - Pack of 48	£3.45
	Ball 3/16 Pack of 48	Ball 3/16 pack of 48	£3.45
	Ball 5/32	Ball 5/32 sold per ball at £0.10 each	£0.11
	Ball 50 x 1/8	Ball 1/8 in a pack of 50	£3.45
	Ball 7/32	Ball 7/32 sold as one ball at £0.10	£0.11
	Bearing MC22	MC22 RS bearing single row bearing 22 x 50 x 17mm. Now with a oil seal in one side also.	£40.00
	Bearing upper race set Veterans and Model H/SD and Ricardo	Bearing upper race set veterans and model H/SD and ricardo Inter and out race no balls	£50.60
	Bolt 1/4 Crankcase domed end 3.900	Crankcase bolt domed end 1/4 thread x 3.900 long with 1.100 long on thread cut down to suit early models	£6.90
	Bolt Crankcase 1/4 stud x 4 1/2 long for exhaust	Crankcase bolt 1/4 threaded both ends used to hold on Exhaust casting one needed.4 1/2 inch long	£4.02
	Bolt crankcase stud 1/4 x 4 1/4 long	Crankcase bolt 1/4 x 4 1/4 long threaded both ends for veteran case . Approximately 4 used in the case plus one long one for exhaust.	£4.02
	Bolt domed head Engine to frame 1/2 x 2.90 long	Bolt domed head Engine to frame 1/2 x 2.90 long	£8.05
	Bolt domed head engine to frame 9/16 x 3 long	Bolt domed head engine to frame 9/16 x 24 tpi x 3 long	£8.63
	Bolt eccentric clamp and nut	Eccentric bolt that clamps pedalling gear casting in the frame with square head nut.	£20.70
	Bolt Engine to frame 3/8 x 2.900 long domed head	Bolt Engine to frame 3/8 x 24 tpi x 2.900 long domed head.	£6.90
	Bolt for Mudguards 1/4 x 1/2 long	Bolt for Mudguards stays 1/4 x 1/2 long with built in washer.	£6.00
	Bolt fork Pivot to spring	Fork Buttress bolt that clamps to the spring housing 5/16 x 30 tpi special thread Thread to under side of head.	£10.00
	Bolt lubrication screws	Bolt lubrication screws 8ba thread with screwdriver slot	£2.30
	Bolt Magneto long square head	Magneto Bolt long square head to bolt the magneto to the platform 3/8 whit thread.	£17.00
	Bolt Magneto short square head	Magneto bolt short square head 3/8 whit to bolt Mag to platform.	£14.50
	Bolt rear Carrier veterans	Bolt rear Carrier veterans 3/8 and a 5/16 thread and 3/8 wide on hex Will need a thin nut and split pin. see nut section thin nut is 3/8 x 24 tpi x 0.16 wide	£12.65

Page
« Prev |1|2|3|4|5|6|7|8| Next »